Yokogawa YFGW410 User Manual download pdf (Page 37)

<C3. Mounting>

C3-3

IM 01W02D01-01EN

C3.3 Installation of the YFGW410

1. Loosen the screws at both sides of the DIN rail mounting bracket (located on the rear panel

of the YFGW410), by rotating these screws in the reverse direction from the “Lock” position.

The screws do not drop even when fully loosened.

2. As shown in Figure C3-3, hook the top edge of the DIN rail mounting bracket onto the top of

the DIN rail, and return the YFGW410 back to the horizontal position. Then, hook the bottom

edge of the mounting bracket onto the bottom of the DIN rail.

3. Tighten the screws at both ends of the DIN rail mounting bracket, by rotating them toward

the “Lock” position. Tighten screws securely to ensure there is no clearance between the

bracket and the DIN rails.

4. Remove the YFGW410 by following the procedure described above in reverse.

After you have tightened the screws, loosen them by three turns.

FC0303.ai

Figure C3-3 Mounting of the YFGW410 on DIN rails

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 201 202

No comments

Yokogawa YFGW410 User Manual Page 37