Yokogawa digitalYEWFLO (DY) User Manual download pdf (Page 35)

INSTALLATION

IM 1F2B4-01-YIA

Page 39

Meter Flange Collar Kit Mark on

Size Rating (4 per set) collar

0.5" 150# F9322GC GL

0.5" 300#, 600# F9322GD GM

1.0" 150# F9322HC HL

1.0" 300#, 600# F9322GA GJ

1.5" 150# F9322GC GL

1.5" 300#, 600# F9322JD JM

2.0" 150# F9322KA KC

3.0" 150# F9322KM KP

Table 3.2.1: Dimensions

Note: Only the above indicated meter sizes require collars

3.2.2 Installing the wafer style vortex meter horizontally

1) Insert two collars (see dimensions table above) on each of the two lower bolts.

2) Place the vortex meter on the collars located on the lower two bolts making sure the arrow

on the side of the meter body is facing in the same direction as the flow.

3) Insert the remaining bolts and tighten all bolts and nuts uniformly.

4) Check for leakage between the meter body and the flanges.

Figure 3.2.1: Wafer type - horizontal installation

3.2.3 Installing the wafer style vortex meter vertically

1) Insert one collar (if required, see table 3.2.1) on each bolt, being certain that the collars are

in contact with the outside diameter of the vortex meter body. Make sure the arrow on the

side of the meter body is facing the same direction as the flow.

2) Tighten all bolts uniformly.

3) Check for leakage between the meter body and the flanges.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 125 126

No comments

Yokogawa digitalYEWFLO (DY) User Manual Page 35